imported_MartinGouda

has any one used this stuff yet?...i have pre tested in on a screw drive and a box and i am really impressed with the colour that it finished with but i am still wondering if that colour will be changed when heat is aplied...the can boasts that it is heat resistant but i an not sure if that is saying that you could paint a engine component that is only exposed to heat or if it can be applied to things like mainfolds, blocks, valve covers and other VERY hot items.....

i saw it done at performance improvments on a demo engine they have in the store but that engine was never run so i dont know what to think....

please let me know if any of you have tried this stuff.....if i end up putting it on and it mess up then i will probably scrap it off with a wire brush and have the cover powder coated....

any ways any info would be greatfully apreciated...

imported_MartinGouda

just used it ....nice paint....good drying time but SHITTY CAN...POOR TIP....TERRIBLE PRESSURE.....i am returning the half a can to see if they will replace it at crappy tire but if not i'll raise a stink and buy a can of krylon to express myself on thier store walls.....

ha ha ha

so far so good....buy i suggest you use another tip if you try to use this shitty stuff cause the crappy plastic tips are shitty and drip and sputter alot....go get some nice graffiti tips they will help...

bbarbulo

iTrader: (2)

So, what's the outcome of the paint on engine parts?