Code 5 HELP :(
#1
Code 5 HELP :(
Ok i got a code 5 after installing a new manifold and cat which means i had to relocate the O2 sensors. After it was done im throwing a code 5 five seconds after startup, which is MAP sensor. I have tried putting in a good sensor with no such luck, and have taken the throttle body off and cleaning the passage out...and again im getting the code. Now my question is, can this code be related to the O2 sensors? I dont know what to do next and its pissing me off Any HELP... PLEASE and thank you
#2
have u tryed to reset the computer to see if it pops up again?
aslo did u discounect the bat before u did the install?
are all the wires and sensors pluged in properly?
what year is your car?
I have the hondata software and scanner at home so if you want to come by we can scan it to get a better location on the problem if u like.
also is the car driveable?
aslo did u discounect the bat before u did the install?
are all the wires and sensors pluged in properly?
what year is your car?
I have the hondata software and scanner at home so if you want to come by we can scan it to get a better location on the problem if u like.
also is the car driveable?
#3
ya i reset it many times but with no luck the code comes up again. The car is driveable, but with the software you got can you pinpoint exactly what the problem is because all im getting is a code 5 and ive tryed swapping sensors anyways you got a pm
#5
When you relocated the o2 sensor, did you cut the wires? If so did you do it between the sensor and the connector? If you did then that can cause a problem......the o2 sensor reads/uses the resitance in the wire between the connector and the sensor, if this was cut, it just changed the reading, which is one way you can be having a problem.
Thread
Thread Starter
Forum
Replies
Last Post
civic_integra
Interior - Audio - Security
11
01-Aug-2005 12:53 PM