imported_hustler_98

so i have a 98 si coupe. i went to take off one morning and there was a bang/crack. the axle broke, so i took it apart, and the end of the axle that goes into the tranny is still stuck in there. its the thickness of a dime, and its at the end of the teeth at the back of the hole... im trying to get a magnet to pull it threw but it doesnt seem that it wants to go threw the teeth... its loose, and when you pull a but it start to come threw the grooves.... but then it sticks, weather there are some burs at the back of the piece or whatever, either way i can seem to get it threw the hole of the tranny....

is there anyway i can get this out without opening up my tranny and dumping it out the casing...

thanks...

newman

hugh, I can't understand what is stuck in your tranny? A dime sized piece of your driveshaft?

chris_si98

hahaha what the **** man

too bad its not LSD.. um. the only thing i can think of is to somehow drill out the center (which would leave ****ty metal grinds in your diff.) and put a drift in that and pry it out. Honestly man.. your screwed, there's no easy way I can think of..

newman.. i think he means whats left of the axle above the snapring broke off inside his diff. Which ive never seen happen and find extremely odd

kwikb16a2

tap it and pull her out

kwikb16a2

hmmm i just read that its loose, hmm i dunnno man.....maybe try a little bit of jb weld attached to a rod or screwdriver and pull her out