Brakes Question
#1
Brakes Question
I had my break pads and routers replaced about 4 months ago because the mech. I took it to said they were gone.
Now I'm driving around and I hear the pads grinding into the routers and they are both gone all over again.
Do you guys think I was screwed over the first time?
The first time was semi-metalic pads btw.
Now I'm driving around and I hear the pads grinding into the routers and they are both gone all over again.
Do you guys think I was screwed over the first time?
The first time was semi-metalic pads btw.
#2
what??? 4 months?? Are you sure that the pads are gone?? did you inspect them??
How do you know that your pads are gone?? did you look at them?? Just because you hear sqeaking noises, it doesn't mean your pads are gone (I hope you know that much).
If the pads are really shot already, then you got scammed big time!!!!
I think its time you learned how to change your own rotors and pads. Its very easy job, and can done by looking at a DIY.
How do you know that your pads are gone?? did you look at them?? Just because you hear sqeaking noises, it doesn't mean your pads are gone (I hope you know that much).
If the pads are really shot already, then you got scammed big time!!!!
I think its time you learned how to change your own rotors and pads. Its very easy job, and can done by looking at a DIY.
#3
if you got it done at canadian tire or anyone else that sells munro pads they seam to make alot of noise even if there good but also if the pads dont have a chafered edge they get sharp and sqeak on the rotors
Thread
Thread Starter
Forum
Replies
Last Post
T-Shirt Ninja
Honda Civic Performance - JDM Discussion
0
27-Aug-2002 09:55 AM
crixsi
Honda Civic Performance - JDM Discussion
6
20-Jun-2002 02:22 PM