Benen Product
#1
Benen Product
The orginal thread was lost during forum upgrade.
I was asking what is a Strong Bar? Is that the replacement for OEM front steel bar?
Also, I see the price between Benen and Spoon are around the same range, are they pretty much the same quality material?
I was asking what is a Strong Bar? Is that the replacement for OEM front steel bar?
Also, I see the price between Benen and Spoon are around the same range, are they pretty much the same quality material?
#4
It was my understanding from one of their posts on ebay a while back that it replaced the rebar under the bumper and as such saves 30 lbs off the frontmost part of the car. But I went to their website to check on the master cylinder brace, and I didn't see sheeyat about the strong bar that would confirm my earlier belief. So if you are serious, call them and ask
#9
Ok smartass, so where in the world does it fit on the back??? Does it replace the rear rebar, or is it like a lower tie brace or what? Why doesn't anyone make a front rebar out of aluminium or better yet, carbon fiber?
#12
It does look like a rebar, to me anyway. I mean that is one helluva piece of metal for a rear low tie bar...
I am not sure if SW20 works for SpeedState, but that shop seems to be located in Scar. I might visit the shop then.
I am not sure if SW20 works for SpeedState, but that shop seems to be located in Scar. I might visit the shop then.
#13
Well, I called SpeedState, and they said they are not selling Benen products at the moment, but that bar goes at the end definitely. It is not a replacement for OEM front rebar, and there is not aftermarket front rebar.
Blah....
Blah....
#14
I am almost positive it is the rear upper strut bar based on the other products offered in the same area ..
www.benen.com
www.benen.com
Thread
Thread Starter
Forum
Replies
Last Post
Rich@OptionJDM
Option JDM - Honda Civic Accessories
2
25-Nov-2008 04:02 PM
imported_vzone
Custom Honda Civic Exterior - Lighting
7
23-Aug-2003 11:21 PM