silentkill03

i am buying an 88 crx si, i want a b16a1 with tranny/ecu watever in there....what do i need for the swap? i know i need...

motor
tranny
ecu
wiring harness
drive shafts

any special linkage needed? what about mounts? can i use B16 mounts or do i need custom mounts??

how much am i looking at to spend without install? can someone hook me up???

the car itself is 5spd..so, i dont need to convert from auto to manual.

punkindrublic

you need custom mounts... and you'll either need a different shift linkage or modify the one you have now... you will need new axles to i believe but i dont know off hand which you'd need

dingus8

you will also need a new clutch and timing belt and water pump....and any other parts that are broekn on delivery....a shop will charge anywhere from 2000-4000 installed...depends if you find a deal or quality....you need mounts to...

red90dx

axles must be 90-93 integra or you can use two left hand with the knuckle from a right hand inner.

Rice Burner

Your harness will work you just need to add 2 wires.

Brett

You'll need a integra shift linkage, yours won't fit anymore.