Average price of head mill and port and polish?
27-Oct-2006, 08:19 PM
#1
Registered User
Thread Starter
Join Date: Dec 2002
Location: London, Ontario
Posts: 1,587
Average price of head mill and port and polish?
hey guys I'm looking at getting a d-series head milled a bit and get a port and polish and was just wondering what are the average prices to pay for the job(s)?
I'm not talking about any shops specific, but just looking for a close range figure to give me an idea.
thanks
btw: sorry if this is in the wrong section, didn't know exactly where to place it
I'm not talking about any shops specific, but just looking for a close range figure to give me an idea.
thanks
btw: sorry if this is in the wrong section, didn't know exactly where to place it
27-Oct-2006, 08:26 PM
#2
I think I've paid a hundie for a milling on a neon head when the headgasket went. dunno about the port and polish part, but if you don't want anything hardcore, just get a dremel sanding drum and smooth out the ridges and isht. don't remove too much material, just smooth it out a lil but leave the sanding texture intact.
27-Oct-2006, 10:32 PM
#3
well i've never paid more than $65 for a resurface/mill....but port and polish usually starts around $600 for a street p'n'p.....if anyone tells you that they will do it for less, don't do it. A good port and polish takes time, and needs to be tested on a flow bench, so that all of the cylinders flow the same cfm.
27-Oct-2006, 11:29 PM
#4
Registered User
Thread Starter
Join Date: Dec 2002
Location: London, Ontario
Posts: 1,587
Originally posted by zeeman
well i've never paid more than $65 for a resurface/mill....but port and polish usually starts around $600 for a street p'n'p.....if anyone tells you that they will do it for less, don't do it. A good port and polish takes time, and needs to be tested on a flow bench, so that all of the cylinders flow the same cfm.
well i've never paid more than $65 for a resurface/mill....but port and polish usually starts around $600 for a street p'n'p.....if anyone tells you that they will do it for less, don't do it. A good port and polish takes time, and needs to be tested on a flow bench, so that all of the cylinders flow the same cfm.
yea never knew on the milling price but i had an idea that the pnp would be around the 700 range.
awesome, thanks guys!
Thread
Thread Starter
Forum
Replies
Last Post
B18C|
Honda Civic Performance - JDM Discussion
8
02-Sep-2007 01:50 PM
imported_bhkb
Honda Civic (+ other) Parts/Accessories for Sale or Trade
1
27-Oct-2005 01:31 PM
imported_sketch
Honda Civic (+ other) Parts/Accessories for Sale or Trade
9
09-May-2005 01:46 AM
