Anybody knows how to do Tie Rod Ends
#2
remove the castle nut and cotter pin,, break the tie rod loose with a mallet or a ball joint breaker. Then they just unscrew off,, mark the existing location or count the number of turns till it comes off. Replace the new one till u reach the mark, thread one new nut and put back the cotter pin. Super simple, u will need an alignment for sure,!!!
#3
If you are precise with your turns and don't move the jam nut that much then you won't need an alignment that bad(if your really broke).. even though I always recommend doing an alignment afterwards. Usually tie rods need a little of heat to unscrew off the inner tie rod.. but maybe you'll get lucky.
#7
Originally posted by Scar96
i hope i get luck and its not seized....what is the whole assembly called?? i think i am leaking some oild from the boot which connect to teh outter tie rod
i hope i get luck and its not seized....what is the whole assembly called?? i think i am leaking some oild from the boot which connect to teh outter tie rod
Thread
Thread Starter
Forum
Replies
Last Post
kaval
Honda Civic (+ other) Parts/Accessories for Sale or Trade
0
08-Aug-2010 12:47 PM
imported_braunzcrx
Honda Civic (+ other) Parts/Accessories for Sale or Trade
1
08-Jun-2006 07:12 AM