imported_hdave

I have the engine, tranny, ecu, wiring harness, drive shafts.
what else do i need along with the brake pedal, clutch pedal, and clutch fluid reservoir?

I have been searching but i cannot find the exact parts other then what i have listed already. Any input is appreciated, thanks.

zeeman

iTrader: (1)

clutch master and slave cylinder with a line connecting the two.
are you sure the auto mounts will work on a manual tranny?

civicnation

i'm also wanting to do this swap. which clylinder is attached directly to the clutch pedal (master or slave)? Where do each of them mount to?

ELGUY

Hi guys, I did this swap pre summer. You'll need the rear tranny mount as well for this swap. Oh yeah, it the master cylindar thats conneted to the clutch pedal. Good luck, its worth it to convert it.

ELGUY

You'll also need the shift linkage!! and shifter

rice-01

and shift boot

Younes Si

and a shift ****

imported_Cablerat

like giving your car a sex change.

imported_loudsubz

if your doing it on an EG your gonna need the manual tranny mount welded on or do some playing around with washers

this is for the tranny mount

you will need a 5 spd pedal cluster as well