Adding intake, not sure if it will fit....
#1
Adding intake, not sure if it will fit....
hey guys, i'm buying an intake off a friend on honda-tech.com and it's the replica J's racing intake.
I have a stock D16Z6 in a 1994 honda civic Si coupe.
The guy wrote this in a PM I sent him:
I then asked him what his car is and what this intake was for and he wrote
Well since he has SiR, he's got b16a2 while standard honda would have a d-series motor....
So would it be safe to say that this intake will fit???
BTW: here is the pic of the "*****" intake
I have a stock D16Z6 in a 1994 honda civic Si coupe.
The guy wrote this in a PM I sent him:
do you have an IAT sensor? you might have to plug the second hole.. i'm not sure if it'll fit your car.. but it should.. the guy buying it from me also had a 94 i believe.. i think the only difference between the 92-95 and the 96+ are the number of holes in the tube.. 96+ has 2 holes, one for IAT sensor and crankcase
I then asked him what his car is and what this intake was for and he wrote
i have a 99 SiR.. it fits the USDM Si, but not the canadian SiR because of the ABS control module.. USDM Si doesn't have ABS.. the intake i bought was for EK
Well since he has SiR, he's got b16a2 while standard honda would have a d-series motor....
So would it be safe to say that this intake will fit???
BTW: here is the pic of the "*****" intake
Thread
Thread Starter
Forum
Replies
Last Post