!*Shift linkage*!
I am swapping a short throw along with linkage from one vehicle to another and am having difficulty getting the linkage out of the tranny. Do i just reef on it until it breaks loose? am i missing a clip or somthing? anyone know why I cant get this linkage out of my damn trans?
|
its called a btich pin. get a small screw driver and a hammer and hammer out that little pin.
http://www.chem.ucla.edu/~lmcphers/d15b/013.jpg |
Make sure the pointy object that you uses is bigger than the pin hole but smaller than the linkage hole (obviously) so the pointy object can rest on the pin while you apply force to the other end to push it out. Anything smaller than the actual pin will (and most likely) go into the pin hole and cause a jam.
This pin works because it expands to apply friction in the linkage hole. Any object inside it will make it expand further which makes it even tighter to get pushed out. You may hit your finger, so be careful. ps. it is called a Spring Pin |
use an air chisel...works like a charm...then once you get it out as far as you can with the air chisel...grab a 8mm punch and hammer, and hammer it out the rest of the way, it'll only take 1-2 more smacks with the hammer/punch and it'll come right out.....thats the easiest way i know of removing the b!tch pin.
|
Thanks for all the help trigga, Nova_Dust and zeeman. I am working the ***** out slowly but surly. RESPECT too you three.
|
All times are GMT -4. The time now is 05:22 PM. |
© 2024 MH Sub I, LLC dba Internet Brands