wb123

Are there any DIY out there?
I am going to be ordering the go-autoworks kit and I was recommended to remove or move the washer fluid bottle..

since this is a daily driver, removing the bottle is not an option..

where should it be relocated to?

MPR

You'll have to figure out where you want to move it to and move/extend the wires and lines for the pump.

I'd just try to find a way to work around it....

D.T.P

I can't remember if autoworks piping goes through the side right by the fender or with a 90deg bend out of the throttle body and straight down?
If the passanger corner is not used, you can relocate to that side. Otherwise I doubt you will have room.

Though I don't see why you would need to relocate. Piping is usually bent so it doesn't hit the washer fluid, nor come close.