forcefedsi

I recently ordered some clear JDM DC5 Type R sidemarkers but they did not come with a harness. Is there a way i can install them without plugging in a harness to the back of the side marker or should i find the proper harness? any help is appreciated. thanks.

Cynikal.Mindset

you can hard wire them...cut the harness plug off and wire them directly as you feel

Midori

what does the plug look like Im sure I could think of a plug that would fit. maybe corner light plugs ??? go to the junkers and get the pig tails. only cost like 4 bucks

Buddah

I basically sorta made my own harness in a sense. What I did was soder(sp?) some female plugs to the length of wire necessary to tap into the signal light harness. Then plug em into the back of the bulb holder. Then I used clear high heat silicone and filled the back with it making sure to get inbetween each terminal. I let it set for about an hour then electrical taped the wires just to help provide some water resistance. And that was it. I've had em for 3 years now and no problems yet. It's probably your best bet because harnesses from Honda are EEK-expensive. heh.