imported_xplizitremix

I have a few small rust spots under the fender and wheel wells i was going to do it myself before the salty winters come


Just wondering what materials in terms of paint, rust proof paint etc i need for this job.

I have the sander , just wondering what procedure to do it in.
I have an idea but i don't want to screw / make anything worst


thoughts & ideas

Might write up a DIY once i'm done too

Credits will be added

kwikb16a2

1. Wire wheel on a drill to strip any crap on there.
2. Clean everything up.
3. Sandblast anything that you touched with the wire wheel.
4. Primer (a few coats if you wish)
5. Rubberized coating last. This stuff wont chip when rocks and crap flies up and hits it.

imported_xplizitremix

whats wire wheel?
i was going to sand it down to the metal, and put some sort of coats of paint etc on it

the usual primer (few coats), rust proof paint,
but i will do the ruberrized coating now that i know there is something of this

kwikb16a2

I used a wire wheel attachment on a drill and took any crap off.....you should do this before sanding because the sandpaper might get clogged fast if theres lots of crap