DIY Door Panel Removal 97 CIVIC EX
16 Attachment(s)
My window was binding on the weather rubber thingy...
It would get stuck halfway... and since its a friday, I took it apart. so if you need to take apart your front driver side door, this should help. its my first diy post, so if you have advice, please post. Here we go! Here are the tools ... 10mm socket, precision flat , and a phillips. The clear tape will be used incorrectly later... Attachment 28526 First, take off the speaker cover with the precision flat. Attachment 28527 And take off the three screws around the speaker. No need to actually remove the speaker, so leave the three screws holding the speaker. Attachment 28528 Grab the handle, and pull from the rear side. The front needs a bit of wiggling. Attachment 28529 This is what it should look like when it comes off. There is two screws, gotta take this off. Attachment 28530 If you have power locks, and power windows, the electrical needs to be unplugged. Attachment 28531 There is one screw on the top door handle. This slides forward and pops out. It can be taken out when the whole panel pops out. When putting it back in, close the door, sit in the driver's seat, push HARD and slide. took me a few tries. which is about 20. Attachment 28532 Be careful with the door latch attachment. This has to be removed carefully. Attachment 28533 Now start pulling out the panel from where the speaker is, towards the rear, and there is three plastic clips. Attachment 28534 Attachment 28535 The whole panel can be lifted upwards. Push all the loose parts through, and the only thing attached should be the speaker. Attachment 28536 Here is the top handle without the panel, to give you a better idea Attachment 28537 Yes, I broke one of the clips.... Attachment 28538 Since I had to remove the window, I had to pull back the plastic. Attachment 28539 If you can move the window all the way up, the bolts align, and can be removed with a socket. Attachment 28540 I just taped it back up... It should be properly glued back with silicone... or wte... Attachment 28526 well, that's my first DIY. ... my power locks isnt working, so I'll be taking apart all the other panels later... i'll post them when i do it. Good luck to all DIY. |
Looks good.
This is a sedan right? |
yup. 4dr sedan....
|
nice
hey nice pics. even i had some similar trouble with my 97 civic..had to take it to my local mechanic.
|
hey do u know how to take out the door weather stripper? mines poppin out.
|
Door weather strip that surrounds the door or the window track stripping? You can remove the window track weather stripping easily by rolling your window all the way down and just pulling the weather strip out. The one surrounding the door has clips almost entirely around the door holding it on, so you have to be careful not to break the clips.
|
All times are GMT -4. The time now is 07:57 PM. |
© 2024 MH Sub I, LLC dba Internet Brands