Sundown

Alright, I'm getting a JDM D15b. I would like to run a P08 ECU, but get it chipped to remove the 180 kph speed limiter.

Also, I'm unsure what O2 sensor to run, I currently have a D15Z1 with a 5-wire wideband. If I ran a P28 I could use a 4-wire, but I would really like to keep the engine and ECU matched.

The engine should use a 1 wire 02, but I know that I don't have the wiring harness from Japan with the engine sooooooo...

1) Where in the GTA could I get a P08 speed limiter removed?
2) Is it possible to make the P08 accept a 4 or 5 wire signal & heater circuit for the USDM O2 sensors?
3) When a P28 is chipped with a P08 program, can a USDM sensor be used?
4) Where in the GTA could I get a P28 chipped with a P08 program?

Thanks for the help.

zeeman

iTrader: (1)

Check PM