Justin’s dad watching us work
Authentic Merino wool wash-mitt FTW, only the best for my clients
Using a deironizing gel, to remove the iron particles stuck on Justin’s car. Remember this statement I’ll bring it up again
I use a sponge to ------ it around, before that though. I use a box cutter to grit lines into it. So that dirt particles that may still be present can sucked into their instead of rubbing onto the paint. Detailing on the cheap 101
------ing the gel around
Here I sprayed some tar remover, I mean industrial strength tar remover. So I wear a respiratory mask for safety.
After that I use clay and clay lube to do a final decontamination on the car for what ever is left.
You just have to gently glide it over the surface, GENTLY!
“Huh, did you say something. Okay back to work”
My Boi is impressed with the shine already, what more can I do to impress him?
Trying to play doctor doctor (taking paint measurements of the car, you know how MUCH paint a Mazda has right)
Polishing prep finally!
Justin takes care of his car, so it was in good condition which means it’s very hard to take the pictures of defects.
Also it was impossible to get a 50:50 shot, here are a few attempts though.
This is the polish side, the right side
Un-polished side, do you guys notice the difference.
Here’s the polished side again
Ohh wait, here’s a good one.
Here’s the side of the hood, yes only a Mazda can we have a “side” of the hood. Damn sharp corners
The eyebrows, because the smiley face wasn’t enough
I took a break polishing, Loose Cannon wanted to rinse his car. Pfff Rinse, we detail here Bay Bee